Social Feed

I’m looking for some help troubleshooting hair algae that’s absolutely destroying my Wallichii.

The Wallichii was planted as tissue cultures when I first rescaped the tank. The hair algae is heavily attached to the stems and manual removal hasn’t been very successful—it doesn’t want to let go of the plants.

My biggest concern right now is honestly the algae. I know my CO₂ isn’t where I want it to be, but the algae is getting bad enough that I’m worried it’s going to kill a huge portion of the Wallichii before I get everything dialed in.

Current setup:
UNS 20
Skylight Hyperspot at 100 percent
Photoperiod: 7:30 AM–3:15 PM
Apt 3 1 pump per gallon during weekly water change
CO₂ via inline atomizer
Parameters (5/30):

• pH: 6.6
• NH₃/NH₄: 0
• NO₂: 0
• NO₃: 20–30 ppm
• GH: 14
• KH: 4
• TDS: 323
• CO2: 65ppm midway through photo period

I’m also struggling to get my CO₂ dialed in consistently. The CO₂ reading was about 65 ppm around the middle of the photoperiod, but I had just turned the bubbles per second down because it was clearly too high. If I lower it enough to avoid overshooting, it seems perfect at lights-on but ends up too low by the middle of the day. If I raise it enough to maintain levels later in the photoperiod, I overshoot and end up where I am now.

I’ve tried manually removing the algae, but it’s so attached to the Wallichii that I can’t really get it off without damaging the plants.

At this point I’m trying to figure out:

• Is this primarily a CO₂ stability issue?
• Is the Hyperspot too much light for this tank?
• Should I be aggressively trimming/removing affected stems?
• What would you do to stop the algae before it wipes out the Wallichii?

Any advice would be appreciated. I’m feeling like I’m chasing multiple problems at once and the algae is winning.

Skip to the actual journal here.

I'm known here for high tech, high nutrient, inert substrate scapes -- but I also love NO tech, rich substrate scapes, too!

This thread is three-sided:

1. To act as a journal for my new No-Tech bowl scape, and
2. To act as a discussion board for no/low tech bowl scapes, and
3. To collect and share accounts and examples of bowl scapes from around the world!

Fishbowls were the OG aquarium, until the hobby helped eliminate them from modern aquarium keeping -- for good reason! Traditional fish bowls were used to house medium-large tropical fish like Bettas in a cramped, unfiltered space, with clown-puke gravel and little to no proper cycling/care/husbandry. We're glad THOSE bowls are gone.

But there is a new modern kind of fish bowl, one where plants, substrate, bacteria, water changes, and proper inhabitant selection all work together to create healthy, mini ecosystem-worlds in our homes:

What does No Tech mean?​

In general, it means that these scapes have:

• No Filter
• No Heater
• No Air Pump
• No Skimmer
• No CO2
• No Circulation

They do have:

• A Light (usually low to medium-powered)
• A Substrate (inert, aquasoil, or sand-capped soil like Walstad method)
• Plants (usually quite low-tech plants, though a surprising number will thrive in this method!)
• Inhabitants (Since these bowls are usually between 2-12 gallons on average, this limits selection to nano fish, shrimp, and snails).

Don't get caught up in the specific label of "no tech" (or worse, gatekeep this method). If you want to use a small filter, or a heater, do it! The concept is still generally the same.

The point is, these are smaller, affordable, beautiful little worlds of light to enliven our living spaces and create art, nature, and beauty -- often with very little maintenance and upkeep besides a partial water change and feeding the fish.

Gallery and Links to bowl scapers:​

Hello everybody im new here and wanted to introduce my tank,

The tank is a 350 liter Juwel rio (120x50x60)
Pretty high tank but wanted to have 50 cm wide

Lights: 3 daytime onex (1x plant 2x colour)
Good for 180 par at the bottom, 1.5 hour build up/5 hours full and 1.5 hour build off

Co2 by Inline with a co2art series pro dual stage regulator dropping 1.4 in ph

Filtration: 2 external filters (1x crystal profi 900, 1x tetra ex 1500 on a spraybar) and a eheim skim 350

Substrate: mastersoil black powder with masterline root tabs

Fertilizer: apt e

Fish: cherry barbels, siamese algae eaters, kuhli, ottociclus and some bloody mary shrimps

Plants: rotala macandra, anubias tinto, reineckii mini, reineckki rosenarvig, rotala blood red, ludwigia repens super red, bacopa carolinia, lobelia cardinalis, crypto flamingo, crypto rosen maiden, staurogene repens, spiralus tiger, ludwigia inclinata meta, samolus parvifloris red.
Might have forgotten something

Currently battling algae and unhappy plants due to nutrient inbalances and a no3 tester that was not correct.

Under a pic of the current state and the state it was a little better in balance (not as it should tho)

The adventure begins...again. After a substantial absence from the hobby, I dunked my toe back in last fall with a small 60F shrimp tank, a Chihiros WRGB slim, and a Chihiros CO2 (citric/baking soda) system. A lot has changed since I started this hobby in the 90s, and it's been about 20 years since I tore my last tank down. 'Aquascaping' per se wasn't as much a thing back then. I didn't know anyone running CO2, and LED lights didn't really exist. The 60F was fun, and the shrimp seem happy, but I have been itching to get to building something with more elbow room.

I did happen to find a pic of my old 75 gallon bowfront tank a few weeks ago that was taken just before I tore it down prior to a big move. It ran great for 7 years. Was a simple low tech setup, with one hunk of driftwood, no rocks, plain gravel (no soil) a lot of simple plants (the sword plants did great), and some peaceful fish. Algae wasn't an issue, filtration was pretty subpar by current standards, but the tank did well despite that, and algae wasn't really an issue. Aesthetically blah by today's standards, and certainly not my goal for this build, but I remember being proud of how well this tank ran back then, and wasn't too demanding. Important as my life was very hectic back then.



So, the tech plan so far for the new 150U:


I ordered the tank and stand from UNS, and to my amazement, despite the worst mid-January winter storm we had in some years here, it was delivered on time by the freight company. I do not recommend trying to move a 5ft wide 400+lb tank and stand across snow and ice, down a slope, into to basement. Very thankful to have a tractor with forks, but still was a bit stressful getting this into the house. Miraculously we got it in the house in one piece, and I seriously questioned ever getting a tank larger than this in the future!



It did require disassembly outside the basement door to actually get it into the house around a berm of snow, along with some extra muscle from a few friends. (This was originally meant to be a 120P, until I realized the hardscape plan I had wouldn't quite fit. What's a another foot in length? )



Just getting the tank through the snow and ice was enough, and the base cabinet and tank just sort of landed in the room, and stayed there for a few days while devising a strategy for the next step. After recruiting a tall and strong friend, and sourcing some of those giant suction cup handles you use for moving shower glass walls, a few days later the tank was finally hoisted up onto the base.

As there is a dropped ceiling in the basement my plan was to hang the lights directly above the tank from the ceiling, rather than using a light stand. A few tiles were removed to investigate the structure above, and with some 2x4 extra bracing for the anchors, as none of the joists were in quite the right spot, two Chihiros Vivid 3 lights were installed directly above the tank. At this point I discovered that none of the electrical circuits in the basement were GFCI protected, so obviously that was immediately remedied. Too much gear and too much water to mess around with unprotected circuits.




With the ceiling open, I decided to run the lighting cables over the top of the wall to the left of the tank, and down into the mechanicals room there. The advantage being that the power cords are hidden from view after going through the ceiling tiles, and it's two less large power sources cluttering up the cabinet under the tank. Had to add an outlet in that closet, but I like how it turned out.

With the tank in position and leveled, and the lights finally installed, the next big issue is water. The well water here is liquid limestone. That was the initial mistake I made with the shrimp tank. Sure, neocaridina like hard water, but not THAT hard, and I quickly had to shift to remineralized distilled. I knew before even getting serious about planning this tank that the only reasonable option, for any future tanks here, is RO. The well water might be fine for Malawi Cichlids, but that's not my plan for this tank, but it will be great to have flexibility going forward. It's a big glass box, at just over 140 gallons, and it won't be the only one here (I hope), so the water part I want to get right from the start, and to make it easy to do water changes. The basement is a walkout, so draining water during water changes will be easy, and I would like to make filling it just as easy. I sourced two 70 gallon storage tanks for the RO water from Northern Tool, and ordered a Vectra S2 pump which will help with transfering water between tanks, as well as pumping it out through a hose to the aquarium(s) during water changes. Forgot to take a pic when I was done, but the pvc is all glued up now. I will finish installing the RO unit this weekend.



So, aquarium set up, lights in, and RO system with storage in progress. Next up? The exciting part. Hardscape! I have been hoarding Manzanita, Hakkai stone, and substrate for several months, so I'm excited to move on to the next step! Tank so far pictured below (although I have already removed the privacy film on the back in favor of adding the ARC RGB light screen in part due to the stair rail being visible and distracting. First screen was damaged in transit, so waiting on a replacement).

This is the future home for the announcements when someone obtains an achievement badge. Let the games begin!

Started a new tank with the idea of show casing Lagenandra meeboldii which I have not showcased before. Wanted to feature Hygrophila lower Hlaingbwe, but I removed it later as I think it would be too large for this tank.

New substrate, new filter, squeezed filter mulm from the other matured tank, then ran the tank one week day before planting. 100% water change after planting, then 100% water change every other day since then. Dosing 1ml APT3 after water change day, and remineralizing to 5dGH using APT Sky. Trying out the low water column dosing approach for the initial period.

Filter: Oase 250
Lights: Week aqua a430 80%
Substrate: APT Feast

Was going to Journal about startup issues, however, it seems like the tank has already stabilized, skipping diatoms and green dust phase.

Freshly planted for a couple of days:
13/2/2026


Replanted the tops for Myriophyllum roraima, Cut and replanted Rotala blood red to begin building up the bush form. Trimmed old leaves
Foreground seems a bit blocky for now, so I think I'lll move stuff round again. Probably when the BV grows out some more.
Pic on 23/2/2026

Readings at this stage:
Potassium: 2.3ppm
Ammonia: 0.1ppm

reduce water changes to 2 times a week.

Amazon prime day is less than 2 weeks away so I thought I'd start a thread in advance to discuss any bargains we might see.

The reason this came to mind now was that I just happen to be browsing for other things when I noticed this small curved edge low iron tank pop up. I would probably buy one of these if it drops even lower for prime day.

10 Gallon Ultra Clear Glass Rimless Curved Edge Aquarium

I’m often out and about working in the field and stumble upon breathtaking examples of often overlooked and under appreciated slices of nature that Florida has to offer.

My neck of the woods is filled with marsh/wetlands ripe with both native and invasive wildlife of all flavors; I want to start a thread where I can document and share.

I’ll update this thread whenever I capture something noteworthy. Much of what catches my eye is aquatic flora, but I try and document anything captivating. I hope you find this as beautiful and fascinating as I do.

Main idea/inspiration:​

Since my main 150p aquarium is in our front room and is the first thing we and our guests see, I can't afford to experiment much with it. I also spent like $600 on aquasoil to fill it, so I thought I'd like to try something different.

This tank will be 100% BDBS substrate, no fertilized substrate. No root tabs (yet), no aquasoil. Only water column fertilization, to challenge myself to see whether I can grow plants well without aquasoil or not! Inspired by the @Burr740 BDBS journals and many other amazing inert-substrate aquariums out there. This isn't a dutch style, only a general "garden" style tank.

I'm thinking about building a monthly subscription box specifically for planted tank hobbyists. Not a generic aquarium box -something focused on the aquascaper side of the hobby.


Each month would rotate through things like:

• Liquid + dry fertilizers to try
• CO2 accessories (diffusers, drop checkers, check valves, etc.)
• A plant sample or tissue culture
• Hardscape/substrate samples
• A care/aquascape tip card

The idea is basically a consumables replenishment box + something new to experiment with each month - aimed at people already running CO2, dosing ferts, and actively growing plants.


Few questions for anyone willing to share:

1. Is this something you'd actually pay for?
2. What would you want to see in it that haven't listed?
3. What would kill it for you (wrong products, bad value, etc.)?

Genuinely just trying to figure out if there's demand before build anything. Honest feedback appreciated - even if it's "no this is a terrible idea.